Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 9" Moser shaft seals
View Single Post
Old April 28th, 2013, 09:44 AM   #1
In Da Faaaaaace!!!
Plato2k5's Avatar
Join Date: 12-25-05
Location: WMU Kzoo Mi / Livonia, MI
Posts: 5,620
iTrader: (17)
Mentioned: 6 Post(s)
Send a message via AIM to Plato2k5
Default 9" Moser shaft seals

Both ends of my 9" are leaking. Not sure if its due to me welding on a truss or not .....

I see there are a few different variations of seals/bearings that are used.

Mine has fluid in the tubes and uses tapper bearings that are not sealed. So it uses the gear oil to lubricate them.

I assume I cannot do this on my own as there is a pressed collar that holes the bearing on, which the seal is behind. Where do you get this done at ?

Jeep is in Kalamazoo as well
Plato2k5 is offline   Reply With Quote
Page generated in 0.13821 seconds with 22 queries