Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - TJ: Engine swap that won't run... need ideas
View Single Post
Old April 23rd, 2013, 07:40 PM   #1
tcxtreme1000
Mud Slut-Hit Every Hole!!
 
tcxtreme1000's Avatar
 
Join Date: 01-25-06
Location: Traverse City
Posts: 2,105
iTrader: (13)
Mentioned: 0 Post(s)
Default Engine swap that won't run... need ideas

So I have a 02 jeep wrangler. The PO had put in a 99 4 liter and I blew that one up so I installed a 2006 4 liter that I was told is new and has only 50 miles on it and after internal inspection I have no reason to doubt it. This new motor came complete with all the 06 sensors in it along with all sheet metal and everything it was even sitting on a chrysler crate. So the motor has not been run in about 5 years and I have swapped out all the sensors from the old motor to the new one and all the plugs are connected along with a new clutch and flywheel. Now when I try to start it, it just back fires and acts like its way out of time.... this ran fine last week on the old motor. I pulled the crank sensor to inspect and it seems fine. I plan on buying a new one tomorrow to try it but I'm pretty sure its something else.

Anyone have any ideas. Help would be appreciated.


Sent from my cm_tenderloin using Tapatalk 2

Last edited by tcxtreme1000; April 23rd, 2013 at 07:46 PM.
tcxtreme1000 is offline   Reply With Quote
 
Page generated in 0.07083 seconds with 20 queries