Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - "The Predator" another YJ build.
View Single Post
Old April 20th, 2013, 10:03 PM   #242
Senior Member
big86inthestixx's Avatar
Join Date: 04-30-11
Location: howard city Mi
Posts: 3,149
iTrader: (9)
Mentioned: 20 Post(s)

Thanks Randy. Im happy with the barn..getting plenty of use out of it.

Here's the acc/cigarette lighter plug for my smart fone charger.

Here is my rigged up rear view mirror mount with a clip to hold my phone. So now I can video and drive at the same time. Whoot!!

Started to work on my rear body armor again tonight. Didn't likebthe tube I had on it before. So I cut it all off and restarted. Its 3/16" plate on the rear, painted red oxide primer right now. Will be painted the Sunkist orange that my jeep is now. And the tube will he black.

This is before tube.

Here is with the tube bent and tack welded on.

Now this pic shows where the outer body armor will have some 1.75" .25" wall dom going from the roll cage IN the jeep to the 3/16 plate on the outside. To give it that much more rigidity. Its only two spots, but I figured for side armor that would h enough.

Hope all this ends up keeping my body together for a few more years.

Next on the list is moving front shock mounts up 1" so I have a little more up travel and can set the jeep a little lower. And to add some sweet progressive rate bump stops up front. And rear soon.
Also want to do some sort of windshield frame protection, I keep smashing it. You can only buy it for TJs. ???

Any ideas?? For windshield protection.

Sent from my SPH-L900 using Tapatalk 2
big86inthestixx is offline   Reply With Quote
Page generated in 0.17202 seconds with 22 queries