Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 2 time award winning Project "YJ-8 Wrambler"
View Single Post
Old April 7th, 2013, 12:58 PM   #76
Senior Member
Wramblerguy's Avatar
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 4,926
iTrader: (11)
Mentioned: 27 Post(s)

So rear axle pinion angle set and perches welded
Shock mounts welded on and shocks on including a new one to replace one that was junk and old drive shaft still works good and is bolted in

Front axle is bolted in, drivers side spring plate took some creative fab work but it turned out good
Shock mounts made and welded on and shocks bolted up
Old brake lines drilled out for slightly larger banjo bolts and bolted on

I got the 33s on it and it looks prety good
It gonna look even better with 35s

I still need to figure out brake lines in the back, make a drag link and figure out/ream a pitman arm
And my master cylinder should be here today
3rd generation jeeper

04 gmc Sierra 2500 crew cab quadrasteer tow pig
87 yj Laredo amc360/ax15/231 amc20/dana30 410s and truetracs
90s Wrambler efi 2.5, t5, built231HD (atlas soon),d44s with 4.88s and detroits
Wramblerguy is offline   Reply With Quote
Page generated in 0.14815 seconds with 22 queries