Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 2WD vs AWD for the street
View Single Post
Old April 1st, 2013, 07:30 PM   #30
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 5,121
iTrader: (63)
Mentioned: 1 Post(s)
Send a message via AIM to bbaXJ
Default

I've got nothing to add that hasn't already been said. I think RWD will be more fun to drive like a pissed off teenager and steer via throttle, but AWB will have a nice unique flavor too it and will perform better for what you have planned if you set it up right. Still planning to use the TJ frame you got from me?

Quote:
Originally Posted by Haggar View Post
Yeah, its easy enough to make AWD, which is the plan. Just debating if I should go 2wd instead.

If I build some outside the frame headers, then I don't have to worry about packaging them past the front driveshaft. I haven't found any outside the frame headers for CJs with LSx motors, except the ones from AA, which are smaller tubes than I want, and aren't for pre-72 CJs...
I've got a set of Speedway DIY header parts for an LS motor if you want it. Flanges, various 1.75" mandrel bent primary pieces, collectors. I bought it off Bryce 3 or 4 years ago and never used it.
bbaXJ is offline   Reply With Quote
 
Page generated in 0.06569 seconds with 20 queries