Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - .060 over bore a bad idea?
View Single Post
Old March 22nd, 2013, 07:48 PM   #1
rubiconwrangler
JEEP350
 
rubiconwrangler's Avatar
 
Join Date: 09-12-07
Location: Taylor, MI
Posts: 224
iTrader: (4)
Mentioned: 0 Post(s)
Default .060 over bore a bad idea?

Chevy 350

Bored .040 now and was getting a bit of blowby, rings and bearings are bad. bad rings caused the groves in the piston to get a lil slopppy as well, so i need new pistons also

4 Bolt main
stock crank
erson rv15h cam Link
Stock heads

Engine is at Rays precision engine in taylor.

They are going to try and hone it out because its not bad, but reccomend boring it out more.

I hear what can happen. but has anyone here actually ran a .060 over and had good or bad experience with it?

Its going back into daily driver jeep 40 miles freeway a day for work. and ocassional offroader, and other fun!!!

Last edited by rubiconwrangler; March 22nd, 2013 at 08:05 PM.
rubiconwrangler is offline   Reply With Quote
 
Page generated in 0.05611 seconds with 20 queries