Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Trans behind a denali
View Single Post
Old March 22nd, 2013, 08:19 AM   #18
circling the drain
kickstand's Avatar
Join Date: 09-20-06
Location: circling the drain
Posts: 35,291
iTrader: (47)
Mentioned: 120 Post(s)

Originally Posted by Gunsworth View Post
I considered calling him out too, but figured id let someone else be the asshole lol.
It's not being an asshole when he posted nothing but useless jibberish.

A simple wiki provides some fairly basic info that probably could answer the OP's question.

An updated 4L60-E, the 4L65-E (RPO M32), was phased in the 2001 model year when coupled behind the 6.0 Vortec. Five-pinion front and rear planetaries, along with a additional 3/4 clutch allowing 7 clutches in the input housing and induction hardened input shaft assembly, were improved to withstand up to 380 ftlbf (515 Nm) of torque.


2005 C6 Corvette
Cadillac Escalade
Cadillac Escalade EXT
Chevrolet Silverado SS
GMC Sierra Denali
GMC Yukon Denali
Hummer H2
Holden Crewman 2004 Only
Holden One Tonner 2004 Only
2005–2006 Pontiac GTO (M32, 3.46:1 final drive)
2002 Isuzu Axiom
The THM700 was renamed "4L60" (RPO MD8) following the new General Motors naming convention, when the electronic version, 4L60-E (RPO M30

Last edited by kickstand; March 22nd, 2013 at 08:24 AM.
kickstand is offline   Reply With Quote
Page generated in 0.18446 seconds with 21 queries