Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - not your typical one ton yj build
View Single Post
Old March 15th, 2013, 05:51 PM   #51
vis_eclipse
ton yj
 
Join Date: 11-18-12
Location: jackson
Posts: 25
iTrader: (1)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by disturbedsledneck View Post
I was under the impression that the XJ springs would move the axle back farther than what it looks on yours. I like the setup you have, and the stance. Maybe that is the route I will go too.
I have the complete frame cut with my motor, so I may try and make the stock 6.0 motor mounts work somehow. It looks to me like I can make them work. I haven't seen anybody else going that route though, so I'm kind of curious if there's a reason that I'm not seeing.
i have them flipped so it stretches the rear back about 2in and i have spring perches with mult. mounting holes for about another inch if ii flipped the spring around the other way it stretches it about 6"
vis_eclipse is offline   Reply With Quote
 
Page generated in 0.07771 seconds with 20 queries