Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - F150 SAS Truggy
Thread: F150 SAS Truggy
View Single Post
Old March 7th, 2013, 08:47 PM   #163
Senior Member
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 861
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007

I have my radiator mount almost finished up. I think I am going to take a small piece of angle and stitch it down to the top plate of the radiator mount to stiffen it. I was suprised how much the 1/4" flatbar would give under not a whole lot of pressure on the adjusting rod. Here are some pics of it. The radiator is isolated between the steel in all clamping portions by 1/4" thick rubber.

jeepxj2007 is offline   Reply With Quote
Page generated in 0.15294 seconds with 22 queries