Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Anyone have experience with cnc plasma tables?
View Single Post
Old March 1st, 2013, 01:17 PM   #12
Senior Member
built's Avatar
Join Date: 12-10-09
Location: warren
Posts: 614
iTrader: (9)
Mentioned: 1 Post(s)

Originally Posted by Bones View Post
do you have the capability to move around larger pieces of metal? the idea of a 4x8 plasma table is great, until you have to move a 4x8 sheet of 3/8" alone... then it sucks.
Yes, back in the day my building was warren engine exchange so there's still two chain falls plus I have two forklifts one of which I'm pretty sure could move a single wide.
built is offline   Reply With Quote
Page generated in 0.47182 seconds with 22 queries