Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Anyone have experience with cnc plasma tables?
View Single Post
Old February 27th, 2013, 07:56 AM   #1
built
Senior Member
 
Join Date: 12-10-09
Location: warren
Posts: 477
iTrader: (7)
Mentioned: 0 Post(s)
Default Anyone have experience with cnc plasma tables?

I've been researching for a hot minute trying to find the best overall value. I'd like to build as much of it as possible myself to save coin. I'd like to use my hand held plasma torch and build either a 4x4 or 4x8 table.

Has anyone pieced together gantry/motors/tracks/ect?

I found some great deals on motors, drivers, and software but that's about it in the deal dept.

I've been leaning toward a complete set up from http://www.procutcnc.com/

Anyone know of any cheap hobbiest set ups?
built is offline   Reply With Quote
 
Page generated in 0.06468 seconds with 20 queries