Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Shop Press Brake
View Single Post
Old February 20th, 2013, 05:56 AM   #1
Senior Member
ckhanna71's Avatar
Join Date: 06-20-07
Location: Vicksburg, MI
Posts: 3,551
iTrader: (52)
Mentioned: 0 Post(s)
Default Shop Press Brake

I finally broke down and bought the steel needed to make a press brake for my 20ton Shop Press. My only complaint was that I wish I would have used 1-1/4" x 1-1/4" x 1/4" angle to accomadate the thicker 3/8" flat stock. I didn't bend it to a full 90deg as I was just testing it out. Next step is to convert the press to Air over Hydro.

ckhanna71 is offline   Reply With Quote
Page generated in 0.21554 seconds with 22 queries