Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 60 High Steer Arms
View Single Post
Old February 18th, 2013, 03:22 PM   #1
jeepxj2007
Senior Member
 
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 834
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007
Default Dana 60 High Steer Arms

I have a set of Kingpin Dana 60 Highsteer arms. They are new and haven't been used. They are made of 3/4" steel cnc torch cut on the outside and machined everywhere else. I believe they have Chevy 1 ton tie rod end taper in the holes as well. These are spring less arms ans come with the hardware shown ( pre load studs nuts two machine washers and zerk fittings) $80 shipped


Last edited by jeepxj2007; February 26th, 2013 at 11:37 AM.
jeepxj2007 is offline   Reply With Quote
 
Page generated in 0.05187 seconds with 20 queries