Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Driver's drop Atlas
View Single Post
Old February 13th, 2013, 12:01 AM   #4
bigblockford79
Big Block Ranger
 
bigblockford79's Avatar
 
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,742
iTrader: (24)
Mentioned: 0 Post(s)
Default

FYI - the case bones has is NOT going to fit your application without some changes. The ford output shaft is 31 spline and requires a much larger input shaft and bearing on the atlas case. You would need to swap the input shaft as well as the input shaft bearing retainer to make it work for your application.
__________________
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
 
Page generated in 0.06125 seconds with 20 queries