Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Steel the basics....
View Single Post
Old February 11th, 2013, 08:28 AM   #1
hztd0m
Senior Member
 
hztd0m's Avatar
 
Join Date: 02-13-06
Location: Fort Worth, Tx
Posts: 336
iTrader: (0)
Mentioned: 0 Post(s)
Default Steel the basics....

I have done a little noob welding, nothing on anything that would drive down the road.

I just got this thing fired up (installed 220 outlet outside, the beauty of living in texas.) Everlast Power Arc 160 and it is awesome to say the least.

Anyway, I am working on converting an old gun safe into a reverse flow smoker. Looking around for plate, angle, flat stock, etc. Been nerdin around the web, and I think the type of steel I am looking for is an A36? Is this correct? It just a smoker so it doesn't have to be extremely strong, just cheap and complatable to 1/8 6011 rod.

That machine is capable of being set up for TIG but I am not quite up to that level of newbness to try it.
hztd0m is offline   Reply With Quote
 
Page generated in 0.05132 seconds with 20 queries