Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - K5 Land Yacht Build
View Single Post
Old February 9th, 2013, 01:30 PM   #52
slowly but surely
89TBIguy's Avatar
Join Date: 01-16-12
Location: Marine City, MI
Posts: 221
iTrader: (0)
Mentioned: 0 Post(s)

Originally the plan was to press off the bearings, but the HF separator wasn't big enough to catch the press plates of the press. So after driving to every parts store around town looking for a suitable puller to rent that was wide enough to to catch my HF bearing separator, I just ended up using a big 2 jaw puller. The separator worked alright but caught one of the needle cages on one bearings but so far it hasn't given us much trouble as far as set up goes.

89TBIguy is offline   Reply With Quote
Page generated in 0.12353 seconds with 22 queries