Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Fuel injecting a 460
View Single Post
Old February 3rd, 2013, 01:12 PM   #6
Senior Member
Join Date: 03-03-10
Location: Stanton
Posts: 168
iTrader: (1)
Mentioned: 0 Post(s)

Originally Posted by camccardell View Post
just need a tweecer module, and you are good to go. have to change some of the variables, but it is just a few clicks of a mouse.
moates quarter has alot better reviews then the tweecer

it should work with the 5.0 harness (some connectors may need to be extended), they're both eecIV so the ignition/injector drivers are on the same spots on the board.

however, if its speed density the load cells will be all wrong and probably wont run well unless you swap out for a 460 ecu (this may require harness mods and some swapped sensors) or a way to tune the 5.0 ecu's values
gear_grinder is offline   Reply With Quote
Page generated in 0.11992 seconds with 22 queries