Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 97 TJ Crawler Full Cage 425hp 327 on propane
View Single Post
Old January 18th, 2013, 01:03 PM   #1
ty_mock
Senior Member
 
Join Date: 10-15-11
Location: Liberty Center/Ohio
Posts: 271
iTrader: (5)
Mentioned: 0 Post(s)
Default 97 TJ Crawler Full Cage 425hp 327 on propane

I have my 97 jeep crawler buggie im parting out to build another project everything will be up for sale with the exception of the axles, tires, links, d shafts and my guages. The whole chassis will be sold Engine, trans, t case, propane set up. I would like to wait till the engine sells to sell the chasis that way it can be ran for a potential buyer. everything located near toledo ohio. Pm or post your number and ill call you back to answer any questions or make arrangements. Most parts were new spring 2012 when i built the project with the exception of the engine. That was built a couple years ago for a mud runner.

Engine $2000
327 chevy with roughly 25-30 hours since built was bored and crank turned
zz4 alluminum gm performance heads
dome pistons
bigger cam roughly .530 lift can remember complete specs
harlan sharp roller rockers that make the cam around a .560
high rise alluminum valve covers
edelbrock victor jr. intake
Holley double pumper with billit base
chrome block hugger headers
Mallory Unilite distributor
Promaster coil and wires
Summit high torque starter
serpentine belt setup with a new alt.

Trans $400, t case $300
700r4
reprogram kit and valve body plate
2800 rpm stahl
241 t case from jeep
super short slip yoke eliminator
has input from a chevy to mate to the gm trans and has a drivers drop front shaft. also still have the input to convert back to a jeep input


I will post up more after work tonight. thanks
ty_mock is offline   Reply With Quote
 
Page generated in 0.06842 seconds with 20 queries