Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 220v single phase
View Single Post
Old January 15th, 2013, 09:15 PM   #2
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,033
iTrader: (20)
Mentioned: 12 Post(s)
Default

Quote:
Originally Posted by FORD FLARESIDE View Post
I have a 3hp motor on my hoist. The wiring diagram in the manual shows a white and a black for hot leads, and a green for neutral. The motor however has two black lead wires labled L1 and L2, with a green neutral.

Is L2 supposed to be the white, or does it even matter?


The electrical diagram from the manual would be better served if it was drawn by preschoolers.
I'm no electrician but I would sure think l1 and l2 would be both hots and it shouldn't matter which is which. That is just my common sense talking though...

You should swing by and have a beer one of these evening's. I'm in the barn almost every night, don't be a stranger!
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.04837 seconds with 20 queries