Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - not your typical one ton yj build
View Single Post
Old January 6th, 2013, 06:44 PM   #16
chevotass
Senior Member
 
chevotass's Avatar
 
Join Date: 11-02-06
Location: goodrich
Posts: 6,597
iTrader: (22)
Mentioned: 19 Post(s)
Send a message via AIM to chevotass
Default

looks good. on your 14 bolt shave. are you going to modify the stock cover or buy an aftermarket one?

mine looked the same as yours the 1st time i shaved and plated one. without adding at least one hole down low i could not get it to seal. I added 2 small holes near the corners where the plate is welded to the housing. i made a custom cover out of 3/16" plate and it sealed great after that.
chevotass is offline   Reply With Quote
 
Page generated in 0.04412 seconds with 20 queries