Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Classic hillbilly engineering
View Single Post
Old December 30th, 2012, 04:38 PM   #24
expert jeep disassembler
chadcooper55's Avatar
Join Date: 08-28-08
Location: kent city mi
Posts: 8,009
iTrader: (20)
Mentioned: 12 Post(s)

Originally Posted by High Center Hancho View Post
there is no engine, trans or transfer case in it...who gives a shit about what angle the driveshaft is sitting at
How about how the pinion is tipped waaay further up than stock and I'm guessing he didn't chop the c's off and roll them back to where they should be? I'm guessing it will drive really sweet.
chadcooper55 is offline   Reply With Quote
Page generated in 0.17978 seconds with 21 queries