Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old December 25th, 2012, 05:08 PM   #362
Bones's Avatar
Join Date: 11-06-05
Location: South Lyon, MI
Posts: 12,507
iTrader: (39)
Mentioned: 25 Post(s)
Send a message via AIM to Bones

Originally Posted by liv2mx View Post
make sure the distance from your left upper and right lower is the same from front to back.does not look like it is.
do you mean upper and lower link seperation? I always like to have difference in the seperation, ususally I aim for 8-9" seperation on the axle and 6-7" seperation on the chassis.

edit- as far as triangulation in the links, I aim for atleast 30deg of triangulation. So for example, if your lowers are straight and parallel to each other, the uppers need to have 30deg triangulation in relation to the lowers. Or, your lowers can have a 10 deg difference to easch other (10 degrees non-parallel), then your uppers canhave a 20 deg difference to each other (combines for 30 deg).
Inviscid Motorsports

Special Thanks and Recommendations to;
Motorcity Machines
Ironman Offroad
Branik Motorsports
Maxxis Tires

Raceline Wheels
PAC Racing Springs
Joint Clutch and Gear

Last edited by Bones; December 25th, 2012 at 05:12 PM.
Bones is offline   Reply With Quote
Page generated in 0.12197 seconds with 22 queries