Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 383 stroker (SOLD!!!)
View Single Post
Old November 26th, 2006, 04:54 PM   #1
Senior Member
quicksilver's Avatar
Join Date: 11-05-05
Location: Livonia, MI
Posts: 512
iTrader: (13)
Mentioned: 0 Post(s)
Default 383 stroker (SOLD!!!)

This was in a car I bought. I have heard it run and it sounded good and had nice power. We only drove it off the trailer and in to the garage. I will post what I was told about this motor but I can not be sure it is true.

383 stroker 350 block(casting number is 3970010) 400 crank, Irone eagle H beam rods, shaved deck, 11:1 compression, 882 heads (casting number is 333882), moroso oil pan 8 qt, aluminum edelbrock rpm intake, 1.5 roller rockers(True), edelbrock elite tall valve covers, MSD 6al ignition box ,aluminum timing chain cover, new balancer and timing tab (dont know the brand but it look nice),mini starter(was not shimed and will need new gear),hooker headers. headers, mini starter and msd box are not pictured but I will include them. I just pulled this motor out. I never ran this motor more that 50 feet so I cant be sure of its condition. There were no knocks or tics when it ran. Only trades I will take would be 68 firebird parts, pontiac 400ci parts. I have this on craigslist but I will toss in an Edelbrock carb to anyone from greatlakes.

Asking 750.00


pics can be found-

Last edited by quicksilver; November 27th, 2006 at 03:52 PM.
quicksilver is offline  
Page generated in 0.15381 seconds with 22 queries