Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Custom jeep / car trailer for sale SOLD!
View Single Post
Old December 1st, 2012, 04:57 PM   #1
Senior Member
cruiserdar's Avatar
Join Date: 07-21-08
Location: Howell
Posts: 414
iTrader: (7)
Mentioned: 1 Post(s)
Default Custom jeep / car trailer for sale SOLD!


I am selling my single place jeep trailer, I built it as a cool cruiser hauler that could also be used as a deck for my slide in pickup camper, basically you can step out of a camper onto the completely flat trailer deck. It has an 1/8" diamond plate deck from tongue to ramps. The front corners are trimmed at the same angle as the tongue but is the equivalent of a 14' deck. Drive over diamond plate fenders, but is extra wide and will probably fit most rigs between the fenders, built in tool box, under mounted spare on a receiver. I special ordered max width 3500 lb. drop axles with 4000 lb. springs...both with Electric brakes, that were just adjusted for the first time a few months ago...the pads and drums are in great shape. Last year i replaced all the spring eye bushings, and used geasable brass bushings for the equalizer. The deck has 5 flush mounted recievers built in to allow for racks or the included benchvise to slide in and out without ugly external stake has 4 11000 lb. D rings in the proper location for a vehicle, but the stake pocket tie downs can be slid in if needed. it also has load leveler mounts attached. Premium Trucklite brand flush mounted lights all around, LED tails with Large 7 pin plug that runs into a junction box and all wiring runs inside the 2x4 1/4" wall tube. It has 16" aluminum wheels and E rated trucks tires, with matching spare. It is about 6 or 7 years old. This is a very nice trailer, could use a fresh paint job but solid and pulls like a dream. Call or text 248- six foour o-3379

$1650 or best

I am looking for a 25-30 foot gooseneck tandem dually low profile.

Last edited by cruiserdar; December 10th, 2012 at 07:55 PM.
cruiserdar is offline   Reply With Quote
Page generated in 0.17197 seconds with 22 queries