Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project: Frankenburban (a 3/4 ton story)
View Single Post
Old November 26th, 2012, 02:01 PM   #8
Senior Member
Join Date: 04-26-12
Location: MI
Posts: 149
iTrader: (0)
Mentioned: 0 Post(s)

too late, pulled that bitch out last night. didn't get much else done, I'll be doing comp numbers on the other engine tonite as well as measure the clutch and check the bearings. Throwout bearing seemed pretty good, I've ran into worse before but since its out I'll likely replace it. Clutch master and slave will be replaced, the master has a leak going into the cab.
Rx7Kevin is offline   Reply With Quote
Page generated in 0.16217 seconds with 22 queries