Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old November 25th, 2012, 05:35 PM   #173
Senior Member
Wramblerguy's Avatar
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 4,928
iTrader: (11)
Mentioned: 27 Post(s)

Originally Posted by CheapThrillB2 View Post
Need that ring to know where my tcase height will end up before i can get the motor set. I did make the mount bracket where it attaches to the block. Plan is to mount bushing at frame and connect to mount bracket on block with tube. Same with trans crossmember, bushings at frame on both sides of trans crossmember. Then an additional support for the tcase itself. Half ass threw the butchered eb dash in it. Looks like that shoild be easy to fit when i order a new blank dash.
Is the dash blank just a flat sheet with a couple breaks?
3rd generation jeeper

04 gmc Sierra 2500 crew cab quadrasteer tow pig
87 yj Laredo amc360/ax15/231 amc20/dana30 410s and truetracs
90s Wrambler efi 2.5, t5, built231HD (atlas soon),d44s with 4.88s and detroits
Wramblerguy is offline   Reply With Quote
Page generated in 0.13807 seconds with 22 queries