Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old November 25th, 2012, 03:45 PM   #164
CheapThrillB2's Avatar
Join Date: 09-06-06
Location: Middleville, MI
Posts: 35,356
iTrader: (67)
Mentioned: 65 Post(s)

Need that ring to know where my tcase height will end up before i can get the motor set. I did make the mount bracket where it attaches to the block. Plan is to mount bushing at frame and connect to mount bracket on block with tube. Same with trans crossmember, bushings at frame on both sides of trans crossmember. Then an additional support for the tcase itself. Half ass threw the butchered eb dash in it. Looks like that shoild be easy to fit when i order a new blank dash.
CheapThrillB2 is offline   Reply With Quote
Page generated in 0.10571 seconds with 22 queries