Big thanks to Alumcj from Motor City Machines for helping me out last night. I had some 2" 1/4 wall tubing to bend and Alumcj helped me bend it since I did not have a 2"die. Bending this stuff is sketchy for sure, infact we actually broke the die doing it. luckily it was in a reapairable spot and everyone was OK when it happend.
I will say its not a good feeling when the bender says KABOOOM....
We also cut out some brackets and frame gussets.
This build is stuck in slow motion but its better than no motion....lol
Thanks again Mike!!!!