Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old November 19th, 2012, 01:43 PM   #58
feva4u's Avatar
Join Date: 04-01-07
Location: Caledonia, MI
Posts: 10,671
iTrader: (12)
Mentioned: 20 Post(s)

Nope, but it sounded great!

Section 257.710c
(4) Notwithstanding subsection (2), a person shall not operate a motor vehicle having lift blocks between the front axle and springs, or with lift blocks that exceed 4 inches in height between the rear axle and springs in addition to those provided by the original manufacturer. Any body lift block shall be of single piece construction and shall not use more than a 3-inch spacer. Any suspension lift block shall use an alignment pin between the axle and the spring, and shall be of single piece construction. Spring shackle replacements shall not exceed the original equipment manufacture length by more than 2 inches, and coil spring spacers are prohibited. All steering components shall be geometrically arranged to function as original equipment manufacture. Welded pitman arms, drag links, and tie rods are prohibited. All parts used to modify the original suspension or height of a motor vehicle shall be factory manufactured and shall meet or exceed the original manufacturer's specifications.

This thread is not about steering or whether or not it's to be a trailer queen.
My Jeep

Last edited by feva4u; November 19th, 2012 at 01:49 PM.
feva4u is offline   Reply With Quote
Page generated in 0.12882 seconds with 22 queries