Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old November 16th, 2012, 06:26 PM   #18
Senior Member
chevotass's Avatar
Join Date: 11-02-06
Location: goodrich
Posts: 7,468
iTrader: (23)
Mentioned: 52 Post(s)
Send a message via AIM to chevotass

Originally Posted by CheapThrillB2 View Post
Problem with oe style is loads and stress of the operating angle diff side will see. the rubber will just get torn shit in five minutes.
bones has been running an oem bushing style on his rear engine buggy and is very happy with it. ive run the standard carrier bearing from surplus center. seem to get about a year out of them before you need to replace them.

i like that design your looking at. i think branik also makes a custom carrier bearing like that. but again its all expensive.

I ran 2" 7075 alluminium links on my last buggy and loved them. but stepping up to 1.25 heims i would probably step up to 2 1/4 or 21/2 links.

my new cruiser is running 2" 1/4 wall dom. i know they will end up bending but it was cheaper than alluminium and worked with the weld in bungs i got with my ruff stuff heim kits.
chevotass is offline   Reply With Quote
Page generated in 0.17536 seconds with 22 queries