Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mr. Beefy's "not quite yet U4 buggy" build
View Single Post
Old November 16th, 2012, 10:41 AM   #2
CheapThrillB2's Avatar
Join Date: 09-06-06
Location: Middleville, MI
Posts: 35,309
iTrader: (67)
Mentioned: 65 Post(s)

In the pic above its 108" wheel base. Not 100% sure where it will end up, and thats not ride hieght, just as high as those stands would lift.

Right now I am waiting...

artec front and rear truss's ordered with coil over tabs.
Ruffstuff bushings and sleeves for motor mounts and crossmember parts.
Northwest np205 clocking ring

Waiting to get started on the bushings so I can get the motor etc in place.

Right now..
96 351 roller motor (donor from eb)
c6 but might change it up or atleast get a long tailshaft c6 instead of short. (donor from eb)
np205 twinsticked
ford front 60 5.38's spicer 35 spline outers, drive flanges, spartan locker(donor from eb)
14 bolt shaved welded 5.38s disc converision(donor from eb)
single ended hyd steering (donor from eb)
4 link front and rear
eb grille/hood/fenders atleast and eb dash
CheapThrillB2 is offline   Reply With Quote
Page generated in 0.80408 seconds with 22 queries