Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - project meh...Home made flat fenders and high line
View Single Post
Old October 29th, 2012, 10:42 PM   #23
sodapop
Support the Sport!
 
sodapop's Avatar
 
Join Date: 11-11-05
Location: Harrison Twp, MI
Posts: 2,015
iTrader: (18)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Jeep Thrills View Post
The fenders are now mounted about 1 1/4 inches higher than stock. I suppose I could just move the mounting holes up and reuse the original latches. The tab for the latch wouldn't be on the flat section of the hood anymore.
That's what I did and it worked just fine. Depending on how much of an angle the top latch is on, you may have to kick out the lower mounting bracket a little bit too.
sodapop is offline   Reply With Quote
 
Page generated in 0.05511 seconds with 20 queries