Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Got a problem, Need help ASAP
View Single Post
Old November 15th, 2006, 10:36 PM   #1
"The Situation"
Mclovin's Avatar
Join Date: 11-07-05
Location: Westland, Mi
Posts: 14,415
iTrader: (15)
Mentioned: 0 Post(s)
Send a message via AIM to Mclovin Send a message via Yahoo to Mclovin
Default Got a problem, Need help ASAP

i bought a Draw tite Factory plug in harness today and hooked up my brake controller well i look at the wiring in the instructions and it dont match up with the wires on the pigtail. So i go probe it with it plugged in in the truck everythings right cept the brake switch wire. its hot with the pedal release then goes out with it depressed ? WTF ! this is facotry dodge wiring ! well i go probe my dads truck . Same thing hot release cold pressed.. his controller works FINE..
So is this the norm ?? is thw wiring harness wrong or is the controller shit ? Cause i hooked it al up and the controller is on til i press the brakes.. so im like wtf out of curiosity hit the overide switch.. smoke comes out of the controller.. I yanked that harness plug out like a pair jeans at a playboy party !
So umm yea.. any ideas
I have this controller
Mclovin is offline   Reply With Quote
Page generated in 0.12234 seconds with 22 queries