Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1982 CJ7 Limited Build
View Single Post
Old August 29th, 2012, 09:26 PM   #53
82cj7ltd
Saved by Grace
 
Join Date: 07-10-12
Location: Waterford MI
Posts: 306
iTrader: (5)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Offroadian View Post
The new lift springs should come with a small wedge shim to tip the pinion up a little.
I would run it that way. It should be fine if we're only talking 2" lift. If it vibrates or if you are considering more lift, Iwould buy or build 1" lift motor mounts to tilt the t-case down a little bit to match the angles better.
o ok well I was plannin on buyin the lift springs from someone on here so I'll have to see if they have a wedge shim to change the pinion angle a bit. I'll look into the double cardan joint as well and see how much that would cost.
82cj7ltd is offline   Reply With Quote
 
Page generated in 0.05187 seconds with 20 queries