Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1994 sfa gmc jimmy (edited 12/17/13)
View Single Post
Old August 23rd, 2012, 01:56 PM   #1
OL RED
workin hard to play hard
 
OL RED's Avatar
 
Join Date: 04-18-07
Location: look behind you ;) or sanford
Posts: 822
iTrader: (20)
Mentioned: 0 Post(s)
Send a message via Yahoo to OL RED
Default 1994 sfa gmc jimmy (edited 12/17/13)

parting out 94 gmc jimmy 4 door sfa

motor is from a 79 with 91 tbi heads intake and throttle body, block is stock 350 bore w/high volume oil pump, heads were tanked and valves reset, installed new comp cams mild rv cam and lifters, new water pump. Runs of a speedway motors standalone tbi harness. $500 for it all

th400 trans rebuilt with shift kit estimated 30 hours of run time, comes with ratchet shifter- $425

gm kingpin dana 60 front 14 bolt rear 4.56 gears both welded, front has high steer arms with spring eliminator compression screws, rear has disc brakes -$900

38x12.50x16.50 tsl swampers a couple have fender rashes, still have lots of tread. - $700

s10 v8 heddman headers-$50

astro van steering box drill and tapped for hydro assist-$50

56" 78-87 rear springs-$50

body+frame setup for sfa-$500

basicly selling everything except for the doubler and h1 wheels

Will not sell tires or axles until either the motor or trans is sold. just so test drives will be available

all is best offer
body related parts are on a qoute basis

Last edited by OL RED; December 17th, 2013 at 02:34 PM.
OL RED is offline   Reply With Quote
 
Page generated in 0.06106 seconds with 20 queries