Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My M416/Adventure trailer build.
View Single Post
Old August 18th, 2012, 04:34 PM   #40
81 inches of fun
jeepfreak81's Avatar
Join Date: 11-10-05
Location: Lennon, Mi
Posts: 13,566
iTrader: (25)
Mentioned: 19 Post(s)
Send a message via AIM to jeepfreak81 Send a message via MSN to jeepfreak81 Send a message via Yahoo to jeepfreak81

Well, the 110V welder that we have used to build a few jeeps seems to be giving up, so we hauled the trailer to my dads and his 220v welder was the rescue!

Welding up the lift frame

Welding on the lid to the lid base, automotive seam sealer will seal the rest before paint.

Mocking up the lift frame

Making brackets

Left front so far

Welding on the rear lid cap

Cutting out the front lid cap

Mocked into place

Closer view

Had to quit early today

Rear view in the light, hitch installed

Drivers side view

Spare tire holder in the hitch mount

Sits fairly tight to the trailer, but you cannot tell in this. This is where it will be for now anyway.

jeepfreak81 is offline   Reply With Quote
Page generated in 0.21649 seconds with 22 queries