After moving axle back i had to re make traction bar, and its bracket. I used this time to separate my bars more from 6" to 9" to help control ths 39.5s a little better.
Old traction bar top, new traction bar bottom..lots stronger 1.5" 1/4" wall dom.
Belly shot, needs a skid plate. On the up side after moving my axle back i could move my cross member up 4" from where it was, this should help lots in the trails. No more droopy gut/muffin top.
Pic of newly installed, 98 dodge ram 2500 master cylinder. Waaaay better brakes. One of the easiest mods to the jeep with tje best results...so far.
At the same time i stretched the rear, may as well shave my 14 bolt, so this is a pre pic..
This is an after the 14 bolt shave..
This is how much was removed.
This is a rear lower shot of the almost finished stretch and shaved jeep...
Sent from my SPH-D710 using Tapatalk 2