Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - diamond plate
Thread: diamond plate
View Single Post
Old July 22nd, 2012, 09:01 PM   #1
Rainbird1099
Titles are over rated
 
Join Date: 03-16-06
Location: Highland
Posts: 1,271
iTrader: (9)
Mentioned: 0 Post(s)
Send a message via Yahoo to Rainbird1099
Default diamond plate

I hve 6 of these.
They are 28-1/2 x 28-1/2" 1 edge has a full length hinge, the side edges have 1-1/2" sides with 1" returns, the fourth edge has a 3-1/2" side, with a 1-1/2" return. The return on these has small rubber bumpers (bumbers should be replaced).
These were originaly made to be doors for compartment areas on a fire truck being restored.

They ere never used. All welds are perfect, the diamond plate itself, could use a cleaning/buffing.

These could be used for anything, trailer, garage shelves, I even thought about attaching a cross beam, and using them as a poker table base.
Could one work as a skid plate?
ramps for a landscape trailer?
I have no clue what these are truly worth, I will ask $70 each $300 for all of them.
Scott
248-885-2164

Last edited by Rainbird1099; August 9th, 2013 at 03:00 PM.
Rainbird1099 is offline   Reply With Quote
 
Page generated in 0.05729 seconds with 20 queries