Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - removing valve springs without removing heads ?
View Single Post
Old July 10th, 2012, 04:31 AM   #9
Ironman Offroad
Cool parts peddler
 
Ironman Offroad's Avatar
 
Join Date: 07-29-10
Location: Saginaw, Michigan
Posts: 1,511
iTrader: (11)
Mentioned: 6 Post(s)
Default

Quote:
Originally Posted by Yota Bill View Post
There is nothing wrong with pulling the springs without pulling the heads. Pulling the heads to do it is not necessarily "doing it right".

Air pressure can be as low as about 75psi or so, but just leave it at whatever pressure you run your shop at (125 or so). Also be careful not to tap the valves with the springs removed. If it breaks the seal on the seat, the valve may drop, and you will be pulling the head then.
Agreed.
Ironman Offroad is offline   Reply With Quote
 
Page generated in 0.05079 seconds with 20 queries