Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - new cam installation/break in oil?
View Single Post
Old July 6th, 2012, 11:57 PM   #1
Senior Member
junkjeep's Avatar
Join Date: 03-21-10
Location: centreville/MI
Posts: 127
iTrader: (4)
Mentioned: 0 Post(s)
Default new cam installation/break in oil?

Ok putting an aftermarket cam in my 78 f150 w/ 351m/400, i know u need break in oil because mosy oils no longer have zinc in them, not sure if i shoild use valvoline vr1 or conventional oil with a breakin additive, also i am wondering if i need to use engine assembly lube for the cam or if ican just coat it in motor oil since i am going to pre pump the oil pump before i start the engine ( oil pump is also new - melling hi volume-) thanks
junkjeep is offline   Reply With Quote
Page generated in 0.16530 seconds with 22 queries