Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Another slightly more than mild XJ build
View Single Post
Old June 9th, 2012, 02:16 PM   #43
RDK_YJ88
Never Lift
 
RDK_YJ88's Avatar
 
Join Date: 06-16-06
Location: Fenton, MI
Posts: 2,962
iTrader: (42)
Mentioned: 1 Post(s)
Send a message via AIM to RDK_YJ88
Default

Finished up the passenger rear.

New U-bolt spring plate, with integrated bump pad. Had to make some relief cuts so I could bend the corners up. I welded up the seam afterwards.






Drilled a 1.75" hole for the tube to slide up into the frame rail.




.25" plate got the same hole to strengthen the unibody rail where the bump stop will be welded on.




Welded the .25" plate to the tube.



Welded to the body.



Finished.




This leaves me around 4" of up travel in the rear and around 3.5" up front, not including the little "squish" I'll get out of the bump stop.
RDK_YJ88 is offline   Reply With Quote
 
Page generated in 0.06063 seconds with 20 queries