View Single Post
Old June 8th, 2012, 09:09 PM   #42
RDK_YJ88
Never Lift
 
RDK_YJ88's Avatar
 
Join Date: 06-16-06
Location: Fenton, MI
Posts: 2,878
iTrader: (40)
Mentioned: 0 Post(s)
Send a message via AIM to RDK_YJ88
Default

Finished up the front bumps.

Comparison between stock fronts and the new ones.



To mount and extend the new bumps, I started with 1.75x.120 Tube and capped off one end.



Once the cap was welded on, I ground it smooth and tapped the center.



Rough comparison between the stock bump in relation to where the new one will sit.




Full bump. May need to trim a bit more.






Here's some quick pics of the 3-link I built some time ago now. Its rusty and muddy now.






Starting the rear bumps tomorrow.
RDK_YJ88 is offline   Reply With Quote
 
Page generated in 0.03977 seconds with 11 queries