Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project Yota Crawler
View Single Post
Old June 5th, 2012, 08:51 PM   #90
Jackstand Wheeler
4Bangler's Avatar
Join Date: 03-19-06
Location: Alpena, Mi
Posts: 1,114
iTrader: (19)
Mentioned: 4 Post(s)

Better take the G/F pics down before this thread turns into one of those....oh well, I might as well start it...

More G/F pics!

(By the way, his truck is tall, but not that tall, she's only 4-foot sumpthin....)

I'm actually getting ready to order a vertical air over hydro bender, I'll be ordering it with 1.5" dies but if you want to buy the 1.75" dies you can use it, probably order it before the end of the month (still waiting for the new truck to show up).

Nothing wrong with the JD2, that's what I had before, but you need a large clear area to do any bending, I had to bolt mine to my car trailer out in the driveway.

I believe Scott Stevens has a tubing bender if you just need a few small bends, or Brett's can do it in the exhaust bender, or Tom Tessemer has an exhuast bender.
(43) Jeeps and counting....a couple of them run, kinda.

Last edited by 4Bangler; June 5th, 2012 at 08:54 PM.
4Bangler is offline   Reply With Quote
Page generated in 0.10948 seconds with 22 queries