Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - OBD1 Scan tool needed
View Single Post
Old June 1st, 2012, 07:32 AM   #7
getting dirty
mudviper's Avatar
Join Date: 12-22-06
Location: Flint
Posts: 943
iTrader: (14)
Mentioned: 2 Post(s)
Send a message via Yahoo to mudviper

Originally Posted by Yota Bill View Post
check injector pulse as well, then do a compression test. OBDI isn't advanced enough to tell you much for this problem, especially if the check engine light hasn't been set off.
Thanks for the advice, will check into how to check for injector pulse. I don't believe the check engine light came on when the car died on me. I tried using starting fluid, but that didn't do anything, but it is not easy to use starting fluid on the design of this engine (3.4L DOHC)
mudviper is offline   Reply With Quote
Page generated in 0.16021 seconds with 22 queries