Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - OBD1 Scan tool needed
View Single Post
Old May 31st, 2012, 06:11 PM   #2
Wheelman
Extreme Mudder
 
Wheelman's Avatar
 
Join Date: 09-05-08
Location: Pontiac, Michigan
Posts: 273
iTrader: (1)
Mentioned: 0 Post(s)
Default

you dont need a tool just jump the two terminals next to each other on the obd port with a wire or paper clip. Then turn the key on and off 3 time the last time leaving it in the on position the last time. Then count the flashes on the check engine light. It will blink a few time then pause then blink again. Like Blink,Blink, Pause Blink,Blink,Blink and that would be 23. It will repeat the code 3 times.
Wheelman is offline   Reply With Quote
 
Page generated in 0.05667 seconds with 20 queries