Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - machining h2 rims
View Single Post
Old May 30th, 2012, 05:30 PM   #5
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,055
iTrader: (20)
Mentioned: 12 Post(s)
Default

If you decide to do it yourself make sure to use lots of wd40 on your bit. It helps to keep the bit from getting clogged with aluminum.
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.04918 seconds with 20 queries