Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - machining h2 rims
View Single Post
Old May 29th, 2012, 04:57 PM   #3
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,055
iTrader: (20)
Mentioned: 12 Post(s)
Default

The old set I had I just took a burr bit on a dremel and opened the hole up on the rim a pinch. The set i have now the previous owner had machined. You don't need to take much off them to make them fit. I would machine all your rims and you shouldn't have to worry about it. Then your spare will fit.
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.04799 seconds with 20 queries