Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project Yota Crawler
View Single Post
Old May 23rd, 2012, 08:41 PM   #82
Locked In
Yotabalt's Avatar
Join Date: 02-22-12
Location: Alpena mi
Posts: 495
iTrader: (1)
Mentioned: 0 Post(s)

Alright Sooo....I am partially ditching the radius arm setup, it binds far too soon for my liking, I knew there was going to be bind but it came before I really am satisfied with, so I pulled the drivers upper arm, checked my flex, and it didn't bind at any point, so it's now 3 linked front/rear....

Also, I got my rear 2" wheel spacers today and that helped my stance quite a bit

This is where ride height is until I get my rusty's- 3" HD xj lift springs...not happy with the stock xj springs, but it flex's and looks good...just working on getting it all straight and to where I'm happy with it.
Yotabalt is offline   Reply With Quote
Page generated in 0.11766 seconds with 22 queries