Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - F150 SAS Truggy
Thread: F150 SAS Truggy
View Single Post
Old May 17th, 2012, 04:43 AM   #115
jeepxj2007
Senior Member
 
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 834
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007
Default

I'm using a tube template program off of google and a grinder, cut it out rough with a cut off wheel and finish it off with a flapper wheel, I can get a lot closer into bends than I can with the notcher I have and most cheaper notchers because I wanst going to spend a few hundred dollars on one that could go cut close to bends....the pain in the butt part is going into the house to print off a template every time you figure out a angle.
jeepxj2007 is offline   Reply With Quote
 
Page generated in 0.05187 seconds with 20 queries