Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - F150 SAS Truggy
Thread: F150 SAS Truggy
View Single Post
Old May 16th, 2012, 09:14 PM   #112
Senior Member
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 861
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007

I fit the front pillars in and the cross bar in. From there I built a little area that I am going to fill in with some nice aluminum to make a gauge area and the steering column will mount to. The area between the cross bar and the front of the body by the windshield is going to be filled with a thin gauge steel to make a dash and fill in some area and make it nicer looking. I have about 4 more pieces of tube to add to the cage and the cage is all done. Then I will work on the pieces tieing the rocker supports to the frame and the rear cage mount to the frame, rock sliders, and the front tube work, but there isnt going to be a whole lot there.

The next two pics are what I have in mind for the last few pieces...

My rear disc brackets came today as well!

Last edited by jeepxj2007; May 20th, 2012 at 07:39 PM.
jeepxj2007 is offline   Reply With Quote
Page generated in 0.12768 seconds with 22 queries